Ninja Performance
  Top » » Fuel » Fuel Injectors » 1700.60.11.D.6 My Account  |  Cart Contents  |  Checkout   
Search
 

Advanced Search
Manufacturers
60K and Tune-up
Accessories
Air-Intake
Apparel and Decals
Audio
Battery-Cables
Bearings
Belts
Blow Off Valves
Body
Boost Controllers
Brackets-Braces
Brakes
Bushing Kits
Cam Gears
Camshafts
Catch Cans
Clutch Master
Clutch Slave
Clutches
Cooling
Crankshaft
Decals and Emblems
Driveline
Electronics
Engine
Engine Management
Engine Mounts
Exhaust
Exterior
Fasteners
Fittings-Adapters
Flywheels
Fuel
  3/S Bolt On Fuel Kits
  Fittings - Adapters
  Fuel Hose
  Gauges
  Clips-Plugs
  Electronics
  Fasteners-Hardware
  Filters
  FPRs
  Fuel Injector Sizing
  Fuel Injectors
  Fuel Pump Power Kit
  O-rings and Seals
  Pumps
Gaskets-Seals-Plugs
Gauge Pods
Gauges
Hoses
Ignition-Plugs
Intercoolers - Piping
Interior
Lighting
Nitrous Oxide
Oil System Parts
Oil-Filters
Oil-Fluids
Package Deals
Piston Pins
Piston Rings
Pistons
Pulleys
Reservoirs
Rods
Sensors-Controllers
Service
Shifters - Parts
Silicone Couplers
Steering
Suspension
T-Bolt Clamps
Tech data
Tools
Transfer Case
Transmission
Turbo
Turbo Timers
Used OEM Parts
Used Parts
Vacuum Hose
Valvetrain
Wastegate
Water/Meth Inj
Wideband
Wrist Pins
Additional Shipping
Other Makes
Injector Dynamics Fuel Injectors 1700CC set of 6 91-99 3000GT Stealth
[1700.60.11.D.6]
$1,500.00 $1,199.99

Injector Dynamics Fuel Injectors 1700CC set of 6 91-99 3000GT Stealth


Features:
Injector Dynamics is proud to release it's new ID7000, offering a high quality solution where none existed before.

See complete specs here : Injector Dynamics ID1000 Specs.

Injector Dynamics fuel injectors are the result of batch testing large quantities of specially modified fuel injectors, and then carefully matching them to within 1%, in sets based on their dynamic flow across the pulsewidth range. The result is vastly superior cylinder to cylinder consistency, even at very low pulsewidths.

In addition to receiving tightly matched injectors, you will be provided with dead time compensation values across the entire pressure and voltage range of the injector. This data will insure that the compensations in your ECU work properly, and your air fuel ratios will remain consistent as atmospheric or voltage conditions change.

With pressure capability in excess of 8 bar this injector has found a home in many different applications.

The ID1000 will maintain strict linearity at flow rates that will satisfy idle and cruise requirements for engines. If you're unsure if these will work in your application, give us a call and we'll help you figure out what it will take.

Nominal Dynamic Flow Rate - 1700cc/min @ 3.0 Bar (43.5 psi) Using Gasoline at 52 Degrees C (125 Degrees F)
Maximum Differential Fuel Pressure - 7.0 Bar (101.5 psi)
Fuel Compatibility - Compatible With All Known Fuels
Electrical Connector - USCAR

Order harness type below from the following
Clips & Pins: INCLUDED - Allows the installer to disassemble the factory connector and re-assemble with the Injector Dynamics (US Car) connector.
Pigtails: Pre-assembled Injector Dynamics connector with 3″ of unterminated wire to allow solder installation.
Plug N Play Adapter 90.1: Direct plug and play adapters.

Impedance:
All ID injector coils have resistance values between 8.5 and 12 ohms. Injectors of this type are referred to as "high impedance", and can be used with all ECU's intended for driving high impedance injectors.

ID injectors should not be used with inline resistors. Any inline resistors, whether factory or aftermarket, need to be removed or bypassed. Failure to remove the resistors will result in incorrect operation of your injectors.

The ID1700 is the most recent offering from the partnership of Injector Dynamics and Bosch Motorsport. The ID1700 was designed to fill the gap between the ID1300 and the ID2000, and like the ID1300, it features corrosion resistant internals making it compatible with all known automotive fuels.

A unique magnetic circuit, resulting from a lengthy development program, makes the ID1700 immune to voltage and pressure sensitivity problems that plague other high impedance high flow injectors. The ID1700 excels at high pressures typical of current automotive systems, and will perform flawlessly in these applications.

The ID1700 was designed to be an all fuel compatible injector, capable of very high flow rates. As such, it will most often be used to deliver E85 to boosted engines, or occasionally, gasoline in extreme high horsepower applications. Neither of these applications requires extended linearity at low flow rates, and so this was given a proportionately lower priority during the design process.

The ID1700 will deliver flawless stoichiometric idle and cruise mixtures on E85, but like the ID2000, should not be expected to do so on gasoline.

If you need flawless drivability on gasoline, the ID1300 will provide this, and is capable of approximately 150hp per injector on E85.

Fits:
1991-1999 Mitsubishi 3000GT (6G72 DOHC)
1991-1996 Dodge Stealth (6G72 DOHC)

Available Options:
Harness Type:
Reviews

See Ninja Performance 

Reviews at Bizrate.com

Click Here For
Ninja Performance
Customer Testimonials

Click for Shopping Cart
0 items
Click for New Items
TEIN S.TECH Keycain
TEIN S.TECH Keycain
$9.99
Click for Specials
Deatschwerks Fuel Injectors 550CC set of 6 91-99 3000GT Stealth
Deatschwerks Fuel Injectors 550CC set of 6 91-99 3000GT Stealth
$429.99
$399.99
Reviews
Write ReviewWrite a review on this product!
Tell A Friend
 
Tell someone you know about this product.
Notifications
NotificationsNotify me of updates to Injector Dynamics Fuel Injectors 1700CC set of 6 91-99 3000GT Stealth
Information
About Us
News and Updates
Service Manuals - Guides
Shipping & Returns
Privacy Notice
Conditions of Use
Contact Us


Copyright © 2017 Ninja Performance