Ninja Performance
  Top » » Fuel » Fuel Injectors » 2000.60.11.D.4 My Account  |  Cart Contents  |  Checkout   
Search
 

Advanced Search
Manufacturers
60K and Tune-up
Accessories
Air-Intake
Apparel and Decals
Audio
Battery-Cables-Hardware
Bearings
Belts
Blow Off Valves
Body
Boost Controllers
Brackets-Braces
Brakes
Bushing Kits
Cam Gears
Camshafts
Catch Cans
Clutch Master
Clutch Slave
Clutches
Cooling
Crankshaft
Dash - Displays
Decals and Emblems
Driveline
Driveshafts-CV Shafts
Electronics
Engine
Engine Management
Engine Mounts
Exhaust
Exterior
Fasteners
Fittings-Adapters
Flywheels
Fuel
  3/S Bolt On Fuel Kits
  Fittings - Adapters
  Fuel Hose
  Gauges
  Clips-Plugs
  Electronics
  Fasteners-Hardware
  Filters
  FPRs
  Fuel Injector Sizing
  Fuel Injectors
  Fuel Pump Power Kit
  O-rings and Seals
  Pumps
Gaskets-Seals-Plugs
Gauge Pods
Gauges
Hoses
Ignition-Plugs
Intercoolers - Piping
Interior
Lighting
Nitrous Oxide
Oil System Parts
Oil-Filters
Oil-Fluids
Package Deals
Piston Pins
Piston Rings
Piston Rods
Pistons
Pulleys
Reservoirs
Sensors-Controllers
Service
Shifters - Parts
Silicone Couplers
Steering
Suspension
T-Bolt Clamps
Tech data
Tools
Transfer Case
Transmission
Turbo
Turbo Timers
Used OEM Parts
Used Parts
Vacuum Hose
Valvetrain
Wastegate
Water/Meth Inj
Wideband
Wrist Pins
Additional Shipping
Other Makes
Injector Dynamics Fuel Injectors 2000CC set of 4 89+ Eclipse - EVO III-VII
[2000.60.11.D.4]
$960.00

Injector Dynamics Fuel Injectors 2000CC set of 4 89+ Eclipse - EVO III-VII


Features:
Injector Dynamics fuel injectors are the result of batch testing large quantities of specially modified fuel injectors, and then carefully matching them to within 1%, in sets based on their dynamic flow across the pulsewidth range. The result is vastly superior cylinder to cylinder consistency, even at very low pulsewidths.

Please note: ID2000 injectors are NOT compatible with gasolines containing MTBE

60mm Length
11mm Upper O-Ring
16mm x 5mm
Denso Square Lower O-Ring
Set of 4

In addition to receiving tightly matched injectors, you will be provided with dead time compensation values across the entire pressure and voltage range of the injector. This data will insure that the compensations in your ECU work properly, and your air fuel ratios will remain consistent as atmospheric or voltage conditions change.

Flowing in excess of 2200cc/min at 3 bar, the ID2000 will provide a smooth stoichiometric idle on small bore engines running E85, and it will do all this while maintaining strict linearity up to 95% duty cycle at 9000rpm

With a pressure capability of 9 bar (130psi) this injector can flow as much as 3700cc/min with excellent low pulsewidth linearity, and has the broadest operating range of any injector on the market.

Each injector includes the necessary adaptor top and electrical connector. The adaptor tops mechanically lock to the injector and also incorporate a 7 micron replaceable filter.

Nominal Flow Rate - 2225cc/min @ 3.00 Bar (43.5 psi) Using Gasoline at 52 Degrees C (125 Degrees F)
Maximum Differential Fuel Pressure - 9.0 Bar (130.5 psi)
Fuel Compatibility - Compatible with Methanol/Ethanol/All Known Hydrocarbon Fuels.
Incompatible with gasolines containing MTBE (specifically VP Q16 or VP Import), or Nitro Methane/Nitro Propane.
Electrical Connector - Denso Female

For use w/ PnP Adapter Denso-EV1 (Part # 90.5)

Impedance:
All ID injector coils have resistance values between 8.5 and 12 ohms. Injectors of this type are referred to as "high impedance", and can be used with all ECU's intended for driving high impedance injectors.

ID injectors should not be used with inline resistors. Any inline resistors, whether factory or aftermarket, need to be removed or bypassed. Failure to remove the resistors will result in incorrect operation of your injectors.

Fits:
1985-1987 TOYOTA COROLLA 4AGEC
1989-1999 MITSUBISHI ECLIPSE 2.0T
1990-1994 PLYMOUTH LASER
1990-1998 EAGLE TALON 2.0T
1991-1992 MITSUBISHI GALANT Turbo
1991-1995 TOYOTA MR2 5SFE
1995-1995 MITSUBISHI LANCER EVOLUTION III
1996-1996 MITSUBISHI LANCER EVOLUTION IV
1997-1998 MITSUBISHI LANCER EVOLUTION V
1999-2000 MITSUBISHI LANCER EVOLUTION VI
2000-2005 TOYOTA CELICA 1ZZFE
2000-2005 TOYOTA MR2 SPYDER
2001-2002 MITSUBISHI LANCER EVOLUTION VII
2003-2005 MITSUBISHI LANCER Turbo
2006-2006 MITSUBISHI LANCER Turbo

Order harness type below from the following
Clips & Pins: INCLUDED - Allows the installer to disassemble the factory connector and re-assemble with the Injector Dynamics (Denso) connector.
Pigtails: Pre-assembled Injector Dynamics connector with 3″ of unterminated wire to allow solder installation.
Plug N Play Adapter 90.5 : Direct plug and play adapters.

Available Options:
Harness Type:
Reviews

See Ninja Performance 

Reviews at Bizrate.com

Click Here For
Ninja Performance
Customer Testimonials

Click for Shopping Cart
0 items
Click for New Items
Clevite Bearings 6G72 Mains High Performance
Clevite Bearings 6G72 Mains High Performance
$79.99
Click for Specials
Mitsubishi 3000GT Stealth Window Regulator Right 1991-96 Non OEM
Mitsubishi 3000GT Stealth Window Regulator Right 1991-96 Non OEM
$99.99
$74.99
Reviews
Write ReviewWrite a review on this product!
Tell A Friend
 
Tell someone you know about this product.
Notifications
NotificationsNotify me of updates to Injector Dynamics Fuel Injectors 2000CC set of 4 89+ Eclipse - EVO III-VII
Information
About Us
News and Updates
Service Manuals - Guides
Shipping & Returns
Privacy Notice
Conditions of Use
Contact Us


Copyright © 2018 Ninja Performance