Ninja Performance 25 Spline 5 Spd AWD Output Shaft and Input Spool Kit (NP25splineOSIS)

Ninja Performance 25 Spline 5 Spd AWD Output Shaft and Input Spool Kit
[NP25splineOSIS] ~~$549.99~~ $449.99

Click to enlarge

Ninja Performance 25 Spline 5 Spd AWD Output Shaft and Input Spool Kit

Replace your old worn out output shaft and input spool with this matched Output Shaft and Spool kit.

When the output shaft is worn, so is the input spool. They should be replaced as a pair. If you only replace one or the other, the worn down teeth of the older part damages and accelerates the wear on the newer part causing premature weak and failure.

*This kit is for a 5 spd 25 spline transaxle and transfer case. Make sure this is the kit you need.

*Made from 8620 Steel

*Heat Treated to a hardness of HRC 57-61

This Transaxle Output Shaft and Transfer Case Input spool is a step above the OEM parts but it is NOT as strong or bullet proof as our 300M Shafts and our Flexor Steel Input Spools.

They can be damaged on higher powered applications, and on repeated hard launches on the street, or even more shocking to the drivetrain, launching on a sticky drag strip.

Know your intended use before purchasing.

For a stock powered to mildly upgraded VR4/RTTT in the 300 to 400 AWHP range this setup works well and we have had great results with both customer builds here at our shop and on customer's cars that build them themselves.

But be honest with yourself and the cars use and power. If you have higher than 400 or so AWHP and WILL be launching it hard either on the street and or track, we would recommend NOT trying to save a few dollars on this setup.

For higher horsepower and track use/launching we would highly recommend stepping up to the Ninja Performance 300M Shaft and Flexor input spool. Seen Here:

Ninja Performance Flexor Spool
Click Here for Ninja Performance Flexor Spool

Ninja Performance 300M Output Shaft
Click Here for 300M Output Shaft

Fits:
Mitsubishi 3000GT VR4 AWD Getrag Transaxle 5 speed 25 Spline
Dodge Stealth RT/TT AWD Getrag Transaxle 5 speed 25 Spline

We currently only carry the NP Output Spool for the 5 spd Transfer case. This kit's Output Shaft will fit the 25 spline 5 Spd and 6 Spd transaxles, the 6 Spd Transfer case is different so the input spool will not work.

As with most aftermarket wear items, this Shaft and Input spool kit can not be warrantied due to breakage caused by abuse, hard launches etc and on cars exceeding stock or near stock power. ANY aftermarket high performance part can be damaged when not used on the correct application or if used in a manner it was no intended for.

If you are looking for a more bullet proof setup and or have a higher horsepower car and or visit the dragstrip often, we highly recommend the 300M/Flexor shaft and spool combo. While we have been selling these for many years with only 1 failure due to a hard launch with bad engine mounts to add to the trauma, they can fail if abused.

Ninja Performance will not be responsible for failure of these wear items unless it is deemed a manufacture defect.

Ninja Performance will not be held responsible for collateral damage caused by part failure.

We offer pressing services!
This requires a 40 ton press. Which we have in our service garage.

Choose the Pressing service below and send your old spool to us. We will press off the bearings and gear, press on your gear and bearings on to your new spool and cover the shipping back to you.

If you choose the Pressing Service Below
Ship your old Spool with both bearings and pinion gear still attached to:
Ninja Performance LLC
324 Depot St
Mount Croghan, SC 29727

Available Options:
Spool Pressing Service:

Customers who bought this product also purchased

Ninja Performance Fuel Rail End Adapter Triangle	Mitsubishi OEM 6G72 DOHC Cylinder Head Exhaust Studs - Set of 7	K&N Bolt On Cone Filter Kit - 3000GT Stealth
Mitsubishi 3000GT Stealth AWD Transaxle Input Shaft Bearing Oring	Deatschwerks Fuel Injectors 800CC set of 6 91-99 3000GT Stealth	Mitsubishi OEM 3000GT Stealth Throw Out Bearing AWD
Ninja Performance 6G72 DOHC Big Bore Lash Adjusters - Set of 24	Mitsubishi OEM 3000GT Stealth AWD Rear Differential Bushing Kit Set of 4	Mitsubishi 6G72 Head Bolt Set - 16 bolts OEM